Microchip PIC24FJ1024GB606T-I/MR

PIC24FJ1024GB606T-I/MR 概要

One of its key features is the dual-partition Flash with Live Update capability, which allows for simultaneous programming of one partition while executing application code from the other. This feature provides flexibility and efficiency in firmware updates. Moreover, the ability to perform over-the-air firmware updates adds a level of convenience and cost-effectiveness for designers and engineers

特徴

CPU
• Modified Harvard Architecture
• Up to 16 MIPS Operation @ 32 MHz
• 8 MHz Internal Oscillator:
• 96 MHz PLL option
• Multiple clock divide options
• Run-time self-calibration capability for maintaining better than ±0.20% accuracy
• Fast start-up
• 17-Bit x 17-Bit Single-Cycle Hardware Fractional/Integer Multiplier
• 32-Bit by 16-Bit Hardware Divider
• 16 x 16-Bit Working Register Array
• C Compiler Optimized Instruction Set Architecture
• Two Address Generation Units for Separate Read and Write Addressing of Data Memory

Live Update
• Dual Partition Flash with Live Update Capability
• Capable of Holding Two Independent Software Applications, including Bootloader
• Permits Simultaneous Programming of One Partition while Executing Application Code from the Other
• Allows Run-Time Switching Between Active Partitions

Low-Power Features
• Sleep and Idle modes Selectively Shut Down Peripherals and/or Core for Substantial Power Reduction and Fast Wake-up
• Doze mode Allows CPU to Run at a Lower Clock Speed than Peripherals
• Alternate Clock modes Allow On-the-Fly Switching to a Lower Clock Speed for Selective Power Reduction

Universal Serial Bus (USB) Features
• USB v2.0 On-The-Go (OTG) Compliant
• USB Device mode Operation from FRC Oscillator – No Crystal Oscillator Required
• Low-Speed (1.5 Mb/s) and Full-Speed (12 Mb/s) USB Operation in Host mode
• Supports up to 32 Endpoints (16 bidirectional)
• Supports Control, Interrupt, Isochronous and Bulk Transfers
• On-Chip Pull-up and Pull-Down Resistors

Analog Features
• 10/12-Bit, up to 24-Channel Analog-to-Digital (A/D) Converter:
• 12-bit conversion rate of 200 ksps
• Auto-scan and threshold compare features
• Conversion available during Sleep
• Three Rail-to-Rail, Enhanced Analog Comparators with Programmable Input/Output Configuration
• Charge Time Measurement Unit (CTMU):
• Used for capacitive touch sensing, up to 24 channels
• Time measurement down to 100 ps resolution

Peripheral Features
• Peripheral Pin Select (PPS) –Allows Independent I/O Mapping of Many Peripherals
• Eight-Channel DMA Supports All Peripheral modules
• Six Input Capture modules, Each with a Dedicated 16-Bit Timer
• Six Output Compare/PWM modules, Each with a Dedicated 16-Bit Timer
• Four Single Output CCPs (SCCPs) and Three Multiple Output CCPs (MCCPs)
• Enhanced Parallel Master/Slave Port (EPMP/EPSP)
• Hardware Real-Time Clock/Calendar (RTCC) with Timestamping
• Programmable 32-Bit Cyclic Redundancy Check (CRC) Generator
• Four Configurable Logic Cells (CLCs)
• 5.5V Tolerant Inputs on Multiple I/O Pins

仕様