注文金額が
$5000TI ISO5852SMDWREP
Driver 5A 2-OUT Inv/Non-Inv 16-Pin SOIC T/R
ブランド: Texas Instruments
製造元部品 #: ISO5852SMDWREP
データシート: ISO5852SMDWREP データシート (PDF)
パッケージ/ケース: 16-SOIC
ISO5852SMDWREP 概要
The ISO5852S-EP device is a 5.7-kVRMS, reinforced isolated gate driver for IGBTs and MOSFETs with split outputs, OUTH and OUTL, providing 2.5-A source and 5-A sink current. The input side operates from a single 2.25-V to 5.5-V supply. The output side allows for a supply range from minimum 15-V to maximum 30-V. Two complementary CMOS inputs control the output state of the gate driver. The short propagation time of 76 ns provides accurate control of the output stage.
An internal desaturation (DESAT) fault detection recognizes when the IGBT is in an overcurrent condition. Upon a DESAT detect, a mute logic immediately blocks the output of the isolator and initiates a soft-turnoff procedure which disables the OUTH pin and pulls the OUTL pin to low over a time span of 2 µs. When the OUTL pin reaches 2 V with respect to the most-negative supply potential, VEE2, the gate-driver output is pulled hard to the VEE2 potential which turns the IGBT immediately off.
When desaturation is active, a fault signal is sent across the isolation barrier pulling the FLT output at the input side low and blocking the isolator input. Mute logic is activated through the soft-turnoff period. The FLT output condition is latched and can be reset only after the RDY pin goes high, through a low-active pulse at the RST input.
When the IGBT is turned off during normal operation with a bipolar output supply, the output is hard clamp to VEE2. If the output supply is unipolar, an active Miller clamp can be used, allowing Miller current to sink across a low-impedance path which prevents the IGBT from dynamic turnon during high-voltage transient conditions.
The readiness for the gate driver to be operated is under the control of two undervoltage-lockout circuits monitoring the input-side and output-side supplies. If either side has insufficient supply, the RDY output goes low, otherwise this output is high.
The ISO5852S-EP device is available in a 16-pin SOIC package. Device operation is specified over a temperature range from –55°C to +125°C ambient.
特徴
- 100-kV/μs Minimum Common-Mode Transient Immunity (CMTI) at VCM = 1500 V
- Split Outputs to Provide 2.5-A Peak Source and 5-A Peak Sink Currents
- Short Propagation Delay: 76 ns (Typ), 110 ns (Max)
- 2-A Active Miller Clamp
- Output Short-Circuit Clamp
- Soft Turn-Off (STO) during Short Circuit
- Fault Alarm upon Desaturation Detection is Signaled on FLT and Reset Through RST
- Input and Output Undervoltage Lockout (UVLO) with Ready (RDY) Pin Indication
- Active Output Pulldown and Default Low Outputs with Low Supply or Floating Inputs
- 2.25-V to 5.5-V Input Supply Voltage
- 15-V to 30-V Output Driver Supply Voltage
- CMOS Compatible Inputs
- Rejects Input Pulses and Noise Transients Shorter Than 20 ns
- Operating Temperature: –55°C to +125°C Ambient
- Surge Immunity 12800-VPK (according to IEC 61000-4-5)
- Safety-Related Certifications:
- 8000-VPK VIOTM and 2121-VPK VIORM Reinforced Isolation per DIN V VDE V 0884-10 (VDE V 0884-10):2006-12
- 5700-VRMS Isolation for 1 Minute per UL 1577
- CSA Component Acceptance Notice 5A, IEC 60950-1, IEC 60601-1 and IEC 61010-1 End Equipment Standards
- CQC Certification per GB4943.1-2011
- All Certifications Complete per UL, VDE, CQC, TUV and Planned for CSA
仕様
パラメータ | 価値 | パラメータ | 価値 |
---|---|---|---|
Manufacturer | Texas Instruments | Product Category | Galvanically Isolated Gate Drivers |
RoHS | Details | Series | ISO5852S-EP |
Mounting Style | SMD/SMT | Package / Case | SOIC-16 |
Minimum Operating Temperature | - 55 C | Maximum Operating Temperature | + 125 C |
Technology | Si | Brand | Texas Instruments |
Features | DESAT Protection, Split Output, Miller Clamp, Power Good, Fault Output, Reset, Soft Turn Off | Moisture Sensitive | Yes |
Product | Isolated Gate Drivers | Product Type | Galvanically Isolated Gate Drivers |
Propagation Delay - Max | 110 ns | Factory Pack Quantity | 2000 |
Subcategory | PMIC - Power Management ICs | Part # Aliases | V62/16623-01XE |
Number of channels | 1 | Isolation rating | Reinforced |
Withstand isolation voltage (VISO) (Vrms) | 5700 | Working isolation voltage (VIOWM) (Vrms) | 2121 |
Transient isolation voltage (VIOTM) (VPK) | 8000 | Power switch | IGBT, MOSFET, SiCFET |
Peak output current (A) | 5 | Output VCC/VDD (max) (V) | 30 |
Output VCC/VDD (min) (V) | 15 | Input VCC (min) (V) | 2.25 |
Input VCC (max) (V) | 5.5 | Propagation delay time (µs) | 0.076 |
Input threshold | CMOS | Operating temperature range (°C) | -55 to 125 |
Rating | HiRel Enhanced Product | Bus voltage (max) (V) | 2121 |
Rise time (ns) | 18 | Fall time (ns) | 20 |
Undervoltage lockout (typ) (V) | 12 |
配送
配送タイプ | 配送料 | リードタイム | |
---|---|---|---|
DHL | $20.00-$40.00 (0.50 KG) | 2-5 日々 | |
フェデックス | $20.00-$40.00 (0.50 KG) | 2-5 日々 | |
UPS | $20.00-$40.00 (0.50 KG) | 2-5 日々 | |
TNT | $20.00-$40.00 (0.50 KG) | 2-5 日々 | |
EMS | $20.00-$40.00 (0.50 KG) | 2-5 日々 | |
登録された航空便 | $20.00-$40.00 (0.50 KG) | 2-5 日々 |
処理時間:送料は地域や国によって異なります。
支払い
支払条件 | ハンドフィー | |
---|---|---|
電信送金 | 銀行手数料 US$30.00 を請求します。 | |
ペイパル | 4.0%のサービス料がかかります。 | |
クレジットカード | 3.5%のサービス料がかかります。 | |
ウエスタンユニオン | charge US.00 banking fee. | |
送金サービス | 銀行手数料は 0.00 米ドルかかります。 |
保証
1.購入した電子部品には365日保証が含まれており、製品の品質を保証します。
2.受け取った商品の一部が完璧な品質ではない場合、当社は責任を持って返金または交換を手配します。 ただし、商品は元の状態のままでなければなりません。
パッキング
-
ステップ1 :製品
-
ステップ2 :真空包装
-
ステップ3 :静電気防止袋
-
ステップ4 :個包装
-
ステップ5 :梱包箱
-
ステップ6 :バーコード配送タグ
すべての製品は静電気防止袋に梱包されます。 ESD 帯電防止保護を備えた状態で出荷されます。
社外の ESD 梱包ラベルには、部品番号、ブランド、数量などの当社の情報が使用されます。
私たちは出荷前にすべての商品を検査し、すべての製品が良好な状態であることを確認し、部品が新しいオリジナルでデータシートと一致していることを確認します。
すべての商品に問題がないことを確認した後、梱包後、安全に梱包し、グローバルエクスプレスで発送します。 優れた耐穿刺性と耐引裂性を示し、シールの完全性も良好です。
私たちは高品質の製品、思いやりのあるサービス、販売後の保証を提供します
-
豊富な商品を取り揃えておりますので、お客様の様々なニーズにお応え致します。
-
最小注文数量は1個からとなります。
-
最低国際配送料は0.00ドルから
-
全商品365日品質保証